[n55david]

Fitment on my f30 was so much easier lol

I want to run a staggered setup with 255's out back on my 240ix (Coupe, m suspension, stock height). what do i want to run out front? What wheel offsets do I need to make this work without spacers or any other bs with camber etc?

[LanceM26]

lol, you need camber plates. 9 width and 40 to 45 offset. Camber should be around -2.5 up front

[LanceM26]

18x8.5 et 40 with Hankook Ventus RS4 245/40, they are wide asf and are closer to a 255 than a 245

[marcthedark]

Originally Posted by LanceM26

lol, you need camber plates. 9 width and 40 to 45 offset. Camber should be around -2.5 up front

Are you describing a 255 square set-up? If the OP goes with 255 in th erear than there is nothing against using 225 in the front (while I prefer square too it is hard to get right unless one is willing to "suffer" through trial and error to a degree)

[LanceM26]

Originally Posted by marcthedark

Are you describing a 255 square set-up? If the OP goes with 255 in th erear than there is nothing against using 225 in the front (while I prefer square too it is hard to get right unless one is willing to "suffer" through trial and error to a degree)

yea, referring to a 255 square

[n55david]

Originally Posted by LanceM26

yea, referring to a 255 square

I'm not gonna do a square setup

[LanceM26]

Originally Posted by n55david

I'm not gonna do a square setup

Front is easy, apex has a fitment guide you can base it off of