10-11-2016, 12:10 PM | #1 |
First Lieutenant
110
Rep 317
Posts
Drives: Melbourne Red 2016 M235i
Join Date: Oct 2008
Location: Escondido, CA
|
Front Bumper (w/ PDC) Removal
Hey everyone!
I am hoping someone could lead me in the right direction to a DIY on removing our front bumper cover, ducts, carrier. etc. I hit a metal plate (which was sitting almost 4 inches tall) around a corner and sheered off my front splitter and the mounting plastics from underneath the car as well. My insurance will count it as an at-fault collision, so I'm going to repair and replace by myself. I am going to attempt to remove everything Thursday, so hopefully I can find some guidance before then! If not I will be posting a very sad DIY.
__________________
Past: 2008 BSM BMW 128i 6sp w/ EU spec interior.
Past: 2010 BSM BMW 128i 6sp +Msport 2016 MR BMW M235i Instagram @project_kristi |
10-11-2016, 10:43 PM | #3 |
Captain
463
Rep 957
Posts |
there are 4 screws, 2 on each side under the wheel wells in the front above the reflector, as well as the front bolts under the weatherstripping for the hood. PDC prb have to disconnect the sensors. Also the bolts on the bottom, in your case attached to the splitter. Its easy to remove the bumper.
|
Appreciate
1
Chris_B109.50 |
10-12-2016, 05:18 PM | #4 | |
Brigadier General
1604
Rep 3,940
Posts |
Quote:
|
|
Appreciate
1
Chris_B109.50 |
05-08-2019, 07:26 PM | #5 | ||
Captain
316
Rep 691
Posts |
Quote:
Edit: Had to squeeze lower in the sides. Bingo!
__________________
Bimmercode best coding options (Basic and Advanced):
https://g20.bimmerpost.com/forums/sh...5#post29807925 |
||
Appreciate
0
|
Post Reply |
Bookmarks |
|
|