THE LARGEST BMW 2-SERIES FORUM ON THE PLANET
| 08-18-2019, 07:49 AM | #1 |
|
First Lieutenant
 174
Rep 336
Posts |
Help: need screw size for o2 sensor at Intake
Long story short is I switched intakes and didn't hold on to my factory screws. Well I probably did but lost them lol.
Anyone know if I can get standard screws at Home Depot tonuse? It's for the b58 engine. The two small screws holding the O2 sensor in at the intake. Thanks! |
| 08-18-2019, 08:25 AM | #2 |
|
Major General
 
1834
Rep 6,989
Posts
Drives: 15 F80 M3, 22 G01 X3 30i
Join Date: Apr 2010
Location: Clayton, NC
|
You're referring to the air-mass meter - according to REALOEM, it's a 4mm x 16mm screw, part no. 07129907551. O2 sensors are part of the exhaust system.
https://www.realoem.com/bmw/enUS/sho...diagId=13_1790
__________________
 2015 F80 ///M3 Sedan 7DCT Tanzanite, 2022 X3 sDrive30i 8AT Brooklyn Grey Last edited by RoundelM3; 08-18-2019 at 08:33 AM.. |
|
Appreciate
0
|
| 08-18-2019, 01:48 PM | #3 | |
|
First Lieutenant
174
Rep 336
Posts |
Quote:
|
|
|
Appreciate
0
|
| 08-19-2019, 07:04 AM | #4 |
|
Major General
1834
Rep 6,989
Posts
Drives: 15 F80 M3, 22 G01 X3 30i
Join Date: Apr 2010
Location: Clayton, NC
|
You're welcome...in the future, REALOEM is your friend!
__________________
2015 F80 ///M3 Sedan 7DCT Tanzanite, 2022 X3 sDrive30i 8AT Brooklyn Grey |
|
Appreciate
0
|
Post Reply |
| Bookmarks |
|
|
