[akrobert9072]

Hello, I have a 2015 BMW M235i and am using ISTA+ on my laptop connected by an ETH cable.

I attached photos of my measures plan, along with some of the errors that pop up on ista and what all I have replaced prior to this just looking to see how i can bypass the hardware actions or remove them from my measures plan so i can program and encode all my modules and run a software update on the vehicle.

Replaced/Repaired Parts:

DME - Repaired
FEM - Repaired
IVM - Replaced
Battery - Replaced
Battery Terminals - Replaced

All fuses are good

The main codes that are concerning me are the Short circuit to ground on b+ and the “Unknown terminal voltage” messages that pop up on ista.