03-13-2024, 09:40 AM | #1 |
New Member
0
Rep 5
Posts |
ISTA+ Can't run measures plan due to hardware actions
Hello, I have a 2015 BMW M235i and am using ISTA+ on my laptop connected by an ETH cable.
I attached photos of my measures plan, along with some of the errors that pop up on ista and what all I have replaced prior to this just looking to see how i can bypass the hardware actions or remove them from my measures plan so i can program and encode all my modules and run a software update on the vehicle. Replaced/Repaired Parts: DME - Repaired FEM - Repaired IVM - Replaced Battery - Replaced Battery Terminals - Replaced All fuses are good The main codes that are concerning me are the Short circuit to ground on b+ and the “Unknown terminal voltage” messages that pop up on ista. |
Post Reply |
Bookmarks |
|
|