09-23-2020, 07:20 PM | #1 |
Second Lieutenant
163
Rep 216
Posts
Drives: 2016 BMW M235i
Join Date: Oct 2019
Location: Cocoa Beach, FL
|
Methanol Questions
I'm for sure getting the BMS Meth kit and I am about to order it, but I just had a few questions that I'm wondering if anyone knew the answer to.
1.) Where do you mount your 2.3 gal tank? 2.) Could I simply use a generic water level gauge to measure the amount left in the reservoir? 3.) What methanol is the best to run? Thanks all!
__________________
|
09-24-2020, 10:17 PM | #2 | |
Second Lieutenant
163
Rep 216
Posts
Drives: 2016 BMW M235i
Join Date: Oct 2019
Location: Cocoa Beach, FL
|
Quote:
__________________
|
|
Appreciate
0
|
09-25-2020, 08:14 PM | #4 | |
Enlisted Member
6
Rep 31
Posts |
Quote:
The kit should have a low gauge sensor. If not grab the snow kit. Expensive but reputable. Any 99.9% from your hardware store. |
|
Appreciate
0
|
10-20-2020, 02:48 PM | #5 | |
3441
Rep 79,212
Posts
Drives: C6 Z06, 09 335i, 10 335xi
Join Date: Dec 2008
Location: www.TopGearSolutions.com
|
Quote:
2) No, the methanol will likely cause it to fail prematurely. You can opt for a low-level float switch. We always recommend inspection of your methanol injection kit, pretty much every time you use your car. It's a safe practice. At that point, you'd know pretty much when to fill Methanol. 3) VPM1 if you can source it locally. Otherwise Boost Juice. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|