02-11-2021, 02:56 AM | #1 |
First Lieutenant
64
Rep 348
Posts |
Hello. Anyone have any idea where this noise could be coming from? This noise is happening when I turn the steering wheel. It's only on the front right and only when the cars been driven for a bit. Also not very consistent in volume, but the attached video captures it well. If I get in my car after it was parked overnight and turn the wheel, it does not make the noise.
Any thoughts? Recently had Dinan springs installed and think that maybe something was done wrong..? Sounds like something is possibly rubbing. Maybe the rubber spring boot? Thanks in advance! Before anyone asks, no that's not coming from the tire rubbing on the ground.
__________________
Pure800 - DS2 HPFP - Nostrum S1 - ER Catless DP - Remus Non-Resonated Catback - BM3 Flex Fuel Kit - Ross V1 VTA PCV - Custom Tunes on MHD/BM3 - xHP Stage 3 - TCKline SA/DA Coils - Apex ARC8s - Vicrez Carbon Fiber CSL Trunk - ALP Laser System - Escort Max 360c with Blendmount + more... | IG: kianf22 |
|
02-18-2021, 05:24 PM | #2 |
First Lieutenant
64
Rep 348
Posts |
Guess I'll just keep driving till something happens lol.
__________________
Pure800 - DS2 HPFP - Nostrum S1 - ER Catless DP - Remus Non-Resonated Catback - BM3 Flex Fuel Kit - Ross V1 VTA PCV - Custom Tunes on MHD/BM3 - xHP Stage 3 - TCKline SA/DA Coils - Apex ARC8s - Vicrez Carbon Fiber CSL Trunk - ALP Laser System - Escort Max 360c with Blendmount + more... | IG: kianf22 |
|
Appreciate
0
|
02-18-2021, 05:39 PM | #3 |
Major General
3081
Rep 5,580
Posts |
I listened and it wasn't familiar with anything I've seen posted before.
It sound like it could be a stiction issue, where something was over tightened ornate tightened enough. You could spray some CRC 3084 Dry Molly Lube where the springs set up high under the tower and down low around the spring shelf /control arm and on sway bar links. Noise wasn't there before Dinan install ? Make sure spring are not upside down and people talk them being directional ( not sure what that means ). Just stick your camera grind and take multiple pictures of both sides then compare. |
Appreciate
1
kianf2264.00 |
02-18-2021, 11:53 PM | #4 | |
First Lieutenant
64
Rep 348
Posts |
Quote:
I didn't do the install myself and the shop I used has been really difficult to get a hold of. I think I'm going to go to a different shop and just have them verify the installation and make sure they tighten everything correctly. Thanks!
__________________
Pure800 - DS2 HPFP - Nostrum S1 - ER Catless DP - Remus Non-Resonated Catback - BM3 Flex Fuel Kit - Ross V1 VTA PCV - Custom Tunes on MHD/BM3 - xHP Stage 3 - TCKline SA/DA Coils - Apex ARC8s - Vicrez Carbon Fiber CSL Trunk - ALP Laser System - Escort Max 360c with Blendmount + more... | IG: kianf22 |
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|