Front Splitter Installation Replacement Screws

Poochie · 07-07-2016, 03:21 PM

I am currently trying to install the OEM splitter on my front bumper, however, BMW supplied some replacement screws w/ washer, to replace the ones that were originally attached to the lower bumper but they don't seem to tread properly. I tried many times to tighten the screw but they seem to only tread half way, then become resistant. After physically looking at the two bolts, they seem to have different tread patterns. Did anyone else have difficulty installing their front splitter and any suggestions ?

Anthony235 · 07-07-2016, 05:24 PM

I had the same issue with mine a few weeks ago. I can't remember exactly, but I think I used a combo of the old screws and the new ones for the 4 that go in the center.

335pilot · 07-11-2016, 07:51 AM

I also had this problem. It's harder to torque in a Phillips screw head versus a hex screw head, and the new ones are longer. So, I used a 90 deg ratchet type screwdriver with short bit, which made it a bit easier. Basically, you really have to put pressure on them when installing, but they will go all the way in. The new screws are likely "cutting new threads" past the half way point.

07-07-2016, 03:21 PM	#1
Poochie Luxury at the redline :) 9108 Rep 7,563 Posts Drives: 2016 M2 Join Date: Aug 2012 Location: NYC iTrader: (3)	I am currently trying to install the OEM splitter on my front bumper, however, BMW supplied some replacement screws w/ washer, to replace the ones that were originally attached to the lower bumper but they don't seem to tread properly. I tried many times to tighten the screw but they seem to only tread half way, then become resistant. After physically looking at the two bolts, they seem to have different tread patterns. Did anyone else have difficulty installing their front splitter and any suggestions ? Attached Images
	Appreciate 0 Tweet Quote

07-07-2016, 05:24 PM	#2
Anthony235 Lieutenant Colonel 715 Rep 1,541 Posts Drives: m235i Join Date: Feb 2016 Location: OC, Ca iTrader: (2) Garage List 2015 BMW [0.00]	I had the same issue with mine a few weeks ago. I can't remember exactly, but I think I used a combo of the old screws and the new ones for the 4 that go in the center.
	Appreciate 0 Quote

07-11-2016, 07:51 AM	#3
335pilot Private 22 Rep 60 Posts Drives: 2015 M235, 2008 335i, 2008 X5 Join Date: Feb 2011 Location: tx iTrader: (0)	I also had this problem. It's harder to torque in a Phillips screw head versus a hex screw head, and the new ones are longer. So, I used a 90 deg ratchet type screwdriver with short bit, which made it a bit easier. Basically, you really have to put pressure on them when installing, but they will go all the way in. The new screws are likely "cutting new threads" past the half way point.
	Appreciate 2 Quote