Quote:
Originally Posted by Silver6spd
I am not sure if the harness has pin mappings on it? I tried to swap pins but was out of my skill set, so I low tecked it. There are only two white wires so I figured just a quick splice would do.
|
Right, Silver6spd. So, just to be clear before we get pictures, is this right?
1. In the looping wires you'll find a white and a white/black wire.
2. You cut these two wires roughly in the center.
3. You connect the wires crosswise so that each wire consists of a white-connected-to-a-white/black wire.
4. You then put a wire connector cap or electrical tape on each and you're all done.
If so, this is an exceedingly simple fix. I'd check this out but my car is in the shop.
Thx.