Diffuser - one problem fixed, one to go
One of my problems was the exhaust tips angled downward, and sat too far down from the diffuser. Fixed that by cutting the inlet into the muffler, taking out a small "pie slice" and welding it back together. Had to get the inlet about 1/2 an inch higher than it was. The first three pictures show the side view and straight on view after being cut and welded. Outlets are much more level and tighter to the diffuser, but still stick out further than I'd like.
The next three pictures show the 2.0 version of the diffuser, using the M2 diffuser and the F22 M Perf. diffuser molded together. Still needs to be primed and painted.
__________________
"Horsepower is a terrible thing to waste."
|