Just got one and i didn't know there is an additional Map-tap kit available if run JB4, but i assumed its a pretty straight forward install, just tapping 2 additional signals, one for dimmer and i for the MAP output. my question for the P3Cars guys here is that if I wanna keep my OBDII plug available for my other devices for track use, can you provide a pin-out diagram so i can cut the OBDII plug of the p3cars cable hardwire it? i assume there is only 4-5 wires, such as CAN-HI, CAN-LOW, Ground, IGN and maybe a 12Vconstant, right?
* I have been doinf customer car audio and electronics for the past 15 years.
|