I just installed SPL monoballs on my M240 rear drive
Results were very worth while .
Tested it at Road atlanta last week
I would recommend it. But there is more NVH
Race shop suggested only doing poly bushings since it is street car but it is a reasonable trade off
They were a bitch to press out and press in
Vorshlag camber plates
KW v2 coil overs
I bought them for $250 on a forum but If I had to do it over again I would have purchased the
Two-piece power flex poly units Less cost , easier install , probably longer life than mono balls and close enough for a street car that is tracked which is not a dedicated race car
Bill
|