So, I finally gotten around to installing the LCI Tail lights; I've had them sitting in my house for about a year. No problems, everything went smoothly until I want to code. I had faults when I turn on the ignition which I ignored assuming they'd clear when the coding complete and most of them did however, two remain:
Collision Warning System inactive
Pedestrian Warning Malfunction
I've checked the coding and everything is correct but still, these two faults remain.
When I removed the OG tail lights, there were two (2) connectors going to each tail light, the 8 pin connector and a small 2 pin connector with two brown wires. In moving from the 8 pin to the 6 pin connector, I chose to remove the connector completely. I put some heat shrink on each of the two unused Brake wires and taped them back to the cable. I also wrapped the small connector in electrical tape and taped it to the cable. As both of those wires are brown, I suspect they are ground wires and I'm wondering if not having this cable connected is causing my problem?
__________________
'17 M2 DCT Long Beach Blue
|