[helloelectro]

Had a Dinan midpipe installed and like several others, was getting some rattling. Looks like the mid pipe is touching the underbody rear cross plate.

Someone mentioned washers. Do they just go in the 4 corners of the middle plate? Do I do the same with the arms? Also, does this cause any issues with the purpose of the braces i.e. effectiveness? Anyone know off top of their head the washer size they used, type and how many? I know, not hard to find out, just will save me a trip post part removal.

I also noticed that the midpipe may need to be turned more. I can't tell if it's hanging too low under that car. Anyone else mind sharing some pics of your's if different, or confirm for me if I need to adjust more? I'm worried once I get the lowering springs in it'll be a bigger issue.

The installers where fighting this issue in that the more they turned it level, the more the muffler tips then angled down.

Some photos attached. Thanks for any advice and input!