[Doug Hoover]

I just added this to my 2016 228i with the N26 engine (I know).
I've read a lot about the install which was a no brainer, except I can't seem to find what I consider a safe, stable place to mount it. I have zip tied it to a piece of tubing about 5/8" in diameter, but I'm not happy.
Dinan says to use only a zip tie thru the two holes in a sort of bracket, so to me it's going to flop around a bit.
I'm not happy.
So can a few of you folks take a picture of where you mounted yours ?

I am happy with the added performance, and while not huge is enough to make this little 2 liter wake up.

Thanks in advance for your pictures.

Doug