[moldcad]

A very important question for Brandon:

With an extreme setup (you know what I mean by that*), does the answer to the all-important question: "will it or will it not rub" depend also on a VMR model chosen? Or - if I'd like to follow one of the examples in this thread - I can safely do it with a different wheel model, as well? (In fact, any wheel model of the given specs)? Thanks,

Piotr

* my definition of "extreme" is:
- tires: definitely wider than OEM (meaning 235/35R19 front, 255/30R19 rear), as IMHO, all the 18->19" wheel conversion w/o wider tires is a futile exercise only serving aesthetic purposes - the M235i needs wider tires!!!)
- wheels: ET low enough to show at least some concavity, but high enough to avoid poking out (even if poking would not mean rubbing)
- all the above with 10-15 mm drop (like on the H&R springs)