Previously I had coated my emblems with 5 layers of black plasti-dip and 4 layers of plasti-dip glossifier. While the change was subtle I really liked it. Unfortunately the coating peeled off of the M and I was forced to remove it. Luckily I found someone on the forums selling his emblems, so I picked those up.
The install is pretty straightforward.
- Line up some painter's tape underneath the current emblems.
- Mark off where each emblem starts and ends.
- Use some dental floss to remove the current emblems
- Clean off the area where the new emblems will go with some detail spray and a microfiber towel. If you don't have detail spray available then some diluted vinegar will help. Also, go get some detail spray.
- Line up the new emblems with the markings you made earlier
- Make sure that the emblems are facing up. E.g. the bottom of the 2 is flatter than the top and for some reason the 5 has a flat top. You'll notice that they're both upside down in my pic. I redid them after the pic.
- Once all of the emblems have been installed remove the painter's tape