Quote:
Originally Posted by nyeager
Soooo I may have a little screwup here and am hoping for some help.
I did some coding but wanted to revert everything back to factory state, so I loaded my car's original FA and loaded original SVT and put my backed up original NCD files in the data folder on my computer.
I activated FA, and then selected the top-level ECU and clicked "code"
Things looked to be going ok until it got to module DME2 after which point I got an error message upon trying to code DME2 and the engine cutoff.
After that Im now getting a check engine error light and also a drivetrain malfunction and a fuel system contin. message.
Any ideas? Can these be cleared ? Can I revert my car back to factory defaults like I tried to do in the beginning?
Sorry for the bother and thanks in advance for any help!
|
you sure you clicked "code" and not "code defaults" ?
you don't need your ncd's when you use "code" as it will reset it automatically to factory settings...
Also i would code only the ECU's you modified instead of all the ECUs
Does the car run?
E-SYS can remove the fault code.
Click "External Applications" in the left menu.
Click "External Application"
Double-click "Transmitter"
Scroll to the bottom and double-click "... Clear all DTCs ..."