Quote:
Originally Posted by allthatisntnow
Mine are actually marginally smaller OD than the TS bush OD by about 1mm. All i could source at the time. There're stainless steel so material is more than robust enough for the purpose they're serving and stresses placed upon them are minimal in comparison to what the bolt is under. Mine are getting installed on the 6th Sept so will post if any issues are encountered (which i highly doubt they will).
|
The TS bushings are aluminum, right? Any reason you went with stainless rather than aluminum for the spacers?
I was thinking if there was any wear point between the TS, spacers and mounting point, worn spacers would be the easiest/cheapest fix... As long as they don't wear to the point of failure!
What's the consensus on stainless steel versus aluminum?