Quote:
Originally Posted by MASH65
Great video... appreciate the post & DIY as this is a mod I've been wanting to do. But all of that tucking in & around the rear seat - the rear seat pops right out, like WAY easy. Just lift up on the front of the bench, no tools needed, and it will pop right off. Then tilt up, pull forward, take it out your driver's side door. Takes <2 mins.
You'll have a lot of easier access to run your wires, tuck them behind the plastic panels & carpeting, and never worry about them popping out or getting crushed.
No criticism of the OP/DIY video meant - just an observation & little tip for anyone looking to do this mod, or any other mod where you need to run wires from the cabin to the trunk.
|
Thanks for the tip (guy in the video is me).
The reason I didn't go about removing the seat is because being a brand new car I didn't want to risk introducing any rattles. So I tried to install in the most minimal way possible whilst still achieving fully concealed wiring.