dradernh cross posting from "spool" & "street" forum...
It finally stopped raining and I was able to get out to run another autocross yesterday with some sticky Hoosier A7 (17/225's).
https://lookaside.fbsbx.com/file/5-1...w9k8juO8HLLSGF
No Accusump installed. I have been messing with a few things and didn't have time to re-install it. The results were not good... I don't have any video since I was getting data, but, there are multiple points in the log where I was seeing low 20's psi oil pressure. As posted earlier, anything over 3,000rpm and I should be seeing 60psi still. The first picture below was a sweeping left hand turn. I saw a minimum of 26.5psi and then again in a sweeping right hand turn I was seeing as low as 23.5psi.
I think I am going to go change my oil and look for metal LOL
Here is a comparison I did last fall of accusump vs no accusump. It works!:
Top log shows 1 single <60psi event (49.5psi). Bottom logs shows that without the Accusump I had multiple ~4x.x psi data points. The 3qt Accusump was doing a decent job at keeping oil pressure supplemented.