Quote:
Originally Posted by BEM-S4
Quote:
Originally Posted by Jcoop901
Leverage is your friend. If the T40 is snug, extend the length of your ratchet by attaching a box end wrench to it or slipping a hollow piece of metal tubing over it. If the T40 strips, try a pair of channel locks as a last resort ONLY! You could always head down to a local shop and have it removed. I mean it shouldn't take 5 minutes and the charge would be minimal.
|
This is accurate info but...
You do not need to remove that bolt in order to install the harness. Just remove the fasteners by the amp, bend it out of the way and reach our hand back there. No need to rip the entire trunk apart. |
Thanks again for heads up on this - I managed to install the harness with just bending the trim out of the way.
Really simple install - most time and effort taken was getting one third of the boot seal back in place!