THE LARGEST BMW 2-SERIES FORUM ON THE PLANET
| Torque specs for rear chassis brace - just installed the M-Performance LSD! |
Post Reply |
|
|
Thread Tools | Search this Thread |
| 12-27-2023, 09:17 AM | #1 |
|
Private
 
25
Rep 51
Posts |
Torque specs for rear chassis brace - just installed the M-Performance LSD!
Anyone have the torque specs for the braces shown below? I can't seem to find them in any of the TIS documents I have saved - usually they show the torque specs on the same page or link them to a separate page.
I had to use an impact driver to get them loose and am thinking I'm supposed to replace the bolts but haven't confirmed that. For now, I've just tightened them very snug by hand. I've found some posts on e90's with similar braces being 100Nm + 90 degrees, but was hoping someone could confirm that for F-series - and do I really need to replace these bolts? Bolts 3 and 4 on RealOEM: https://www.realoem.com/bmw/enUS/sho...diagId=51_8755  
__________________
2019 M240i Convertible
- Mineral White/Cognac Interior - 034Motorsport P34 Air Intake/Remus Axle-Back Exhaust/M-Performance LSD - BimmerWorld TA5R - 18x8.5 +38/Michelin PS4S 235/40/18 Square |
Post Reply |
| Bookmarks |
|
|
