[pedro2u]

Originally Posted by AlpineE93

Just went and tried, this method took me about 1 min. Close one side of the cup holder, get the smallest flat head screw driver possible (like super fuckin tiny) wedge it between the clip and the base of the cup holder and pry.

I struggled to replace mine without success yesterday... where in the pic is the clip and base you refer to? I've stuck flat tools in every crevice it seems, and pry tools all around the outside! I have the replacement part in my hand and can't see any obvious places that a clip would engage

Appreciate you've successfully done this and can share the magic!

[S65Hunter]

Originally Posted by pedro2u

I struggled to replace mine without success yesterday... where in the pic is the clip and base you refer to? I've stuck flat tools in every crevice it seems, and pry tools all around the outside! I have the replacement part in my hand and can't see any obvious places that a clip would engage

Appreciate you've successfully done this and can share the magic!

"]https://ibb.co/bdBfpFJ][/url][/URL]

[christosPap]

Originally Posted by AlpineE93

"]https://ibb.co/bdBfpFJ][/url][/URL]

Thanks for the picture. I am also having problems taking the cup holder out. I tried prying at the points you are showing, but I had to stop because I felt I was getting close to braking it.

I plan to paint it in situ, after I cover the rest of the area.

[T_M]

Just finished replacing mine, and found a very simple method to undo the hinges. Insert flathead screwdriver into the slot and twist/rotate it so the screwdriver is causing the main body to flex inward away from the hinge. It literally just pops up and out when you do that.