03-04-2016, 07:06 PM | #1 |
Major
1631
Rep 1,422
Posts |
F Series OBDII CANbus Interface
Has anyone done this update to his/her 2er? F Series OBDII CANbus Interface http://www.burgertuning.com/N55_JB4_upgrades.html I didnt use the Posi-taps when my JB4 was installed. Soldered the wires instead... Hindsight. Please chime in yall. Thank you kindly. |
03-04-2016, 08:12 PM | #2 | |
Captain
308
Rep 647
Posts |
Quote:
|
|
Appreciate
0
|
03-04-2016, 09:45 PM | #3 |
BD_e92
358
Rep 1,748
Posts |
Unfortunately this is nothing new fellas! I have been running this setup almost a year now and it has been flawless. Very easy to do as well, if you have your connection via positap all you do is remove them and then positap those wires to the OBDII harness and then run it through your driver side foot well and plug right in
|
Appreciate
0
|
03-05-2016, 02:23 PM | #8 |
Brigadier General
1779
Rep 4,516
Posts |
If you change canbus from positap to obd2 then DL obd2 FW once you have completed the install
__________________
Fettled M135i EB AT then AW M2 DCT - both gone but not forgotten:
Current '22 X3M LCI.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|