[Doubleojon]

Hello, has anyone installed the M Performance front splitter without the tape? Asking as I’m considering doing this so that I can easily remove it during the winter

[Doubleojon]

Anyone? Bueller?

[Dom147]

it wouldn't be secure without the tape. Using double sided tape still makes it removable. Unless you're using BMW's betalink then I think you're fine.

[XAMI]

I tried a bit and it seemed like it would be way too much work, and theres a chance the bumper was scuffed when applying the glue crap by the dealer. (the middle piece was broken off when i bought the car)

So i gave up on removing the remaining parts and wrapped them instead:
https://www.2addicts.com/forums/show....php?t=2027577

[Doubleojon]

From personal experience I can say that I don’t want to go through the hassle of removing the adhesive each winter; it’s a pain in the ass and the risk of damaging the paint increases each time.

I currently have the splitter from Lightweight on, and that mounts with screws only. Granted, it has far more screws than the OEM MP splitter.

Of note, the smashed MP splitter that was replaced by the Lightweight splitter was installed using the adhesive, but the adhesive had peeled away from the splitter.

[pavimanike12]

people have installed the M Performance front splitter without the tape. They have done this by using self-tapping screws to attach the splitter to the bumper. This is a viable option, but it is important to note that it will not be as secure as using the tape. Additionally, if you are not careful, you could damage your bumper by overtightening the screws.
Clean Master