02-20-2015, 02:33 PM | #1 |
Brigadier General
1836
Rep 4,203
Posts |
P3Cars vent gauge & BMS Stage 1 tune
So,
Anybody running a P3Cars vent gauge and a BMS Stage 1 piggy back tune? If so can you tap into the harness the same way you do with a JB4 to get the correct boost readings? Just checking if this is possible and if someone is running this can you post a "how to" guide to install Thanks, Eric Last edited by horsepower_and_hounds; 02-20-2015 at 08:37 PM.. |
02-21-2015, 06:40 AM | #2 |
Joint Chiefs of Staff
4911
Rep 115,980
Posts |
Yes, just contact Rick for setup directions. It's as easy as running a wire inside the cabin and connecting to the map sensor on jb.
I am running the gauge on my car and will be doing this tap shortly as well on our f80 which will be pretty much the same as yours in terms of steps. Mike |
Appreciate
0
|
02-22-2015, 07:48 AM | #6 |
Brigadier General
1836
Rep 4,203
Posts |
Last question:
For those who run wires from the cab to the engine compartment I found a sweet place to route the wire to run the boost wire from the MAP to the P3Cars V-gauge http://www.2addicts.com/forums/showthread.php?t=1096036 Last edited by horsepower_and_hounds; 03-10-2015 at 05:33 AM.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|