[zombem235]

So iam lookin for a little more ground clearance and ive already damaged it a bit. Lookin to remove lower lip. Any thoughts? Thanx in advance. See pic

[TonM3]

Originally Posted by zombem235

So iam lookin for a little more ground clearance and ive already damaged it a bit. Lookin to remove lower lip. Any thoughts? Thanx in advance. See pic

I don't know if you can, but I have seen some stick on bumper sleds that you can put on to take the damage.

There is a good looking one called scrape armor but super expensive for what it is.

[AndDown]

Originally Posted by TonM3

I don't know if you can, but I have seen some stick on bumper sleds that you can put on to take the damage.

There is a good looking one called scrape armor but super expensive for what it is.

I had the Scrape Armor installed and it's saved my M Sport bumper a couple of nasty scrapes. It's a fairly straight forward install with the supplied glue and screws. I paid around $300 or so for the kit. It barely shows as seen in pics 2 & 3. Comes in 3 pieces for the two sides and the center.

[dradernh]

Originally Posted by AndDown

I had the Scrape Armor installed and it's saved my M Sport bumper a couple of nasty scrapes. It's a fairly straight forward install with the supplied glue and screws. I paid around $300 or so for the kit. It barely shows as seen in pics 2 & 3. Comes in 3 pieces for the two sides and the center.

Thanks for the review. The Scrape Armor looks modestly priced compared to the bumper covers I've had replaced and/or repainted in the past.

I scraped my bumper yesterday; the scrape wasn't too bad, but it was loud enough that I was afraid of what I was going to find. I think I'll pick one of these up.

[zombem235]

Input is great and those look great. What iam mainly lookin for is can that lowest lip that has damage in the middle be removed or does it need to be cut off? Iam actually trying to increase my clearance from street to bumper