04-23-2016, 08:25 PM | #1 |
Private
9
Rep 89
Posts |
JB4 OBDII Question
I purchased the OBDII upgrade plug for a F series stage 2 rev 1 board. Do I still need to connect the red/black power wires? I know I need to update the firmware. Thanks
Edit: Nevermind I see I need them. Last edited by Hoog23; 04-24-2016 at 11:53 AM.. |
04-25-2016, 07:33 PM | #2 |
Joint Chiefs of Staff
24193
Rep 190,805
Posts |
You need to connect the wires to your OBD extension that you have purchased
Note for everyone else reading: OP has the old version of the JB4 that uses POSI-TAP wires. New version JB4 will not need to do this
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
1
|
Post Reply |
Bookmarks |
|
|