Quote:
Originally Posted by Delnari
Would need to confirm with RaceChip tech. support if the bypass plug can be left in so you are running the car in stock mode. The instructions only mention using the bypass plug as a reset device to use before removing from the car. Could be a electronic reset for the cables before plugging the factory cables back in.
|
Yup I did this last week to test the Torque Pro HP/TQ/Boost reader and plugged back in after 2 mile run.
Quote:
Originally Posted by pikcachu
the plug just closes the circuit so the signal goes unmodified to the ECU between the stock out connector and the rc in connector....
basically you disconnect the rc box and connect the plug which just connects the 2 wires... making it just a longer wire from the sensor to the ECU.... nothing else...
|
For you pik
http://f30.bimmerpost.com/forums/sho...9&postcount=22