Quote:
Originally Posted by BimBimM2
Quote:
Originally Posted by Poochie
Quote:
Originally Posted by BimBimM2
Quote:
Originally Posted by Poochie
Quote:
Originally Posted by DriftCarHero
For VLD and Anti-Dazzle you need to go into Expert Mode on the Front Electronic Module.
Module 3073
Options
C_AFS_ENA
LUT_FLC_FORWARDLIGHTING_Y
C_HBA_ENA
C_HBA_GRHB_ENA
C_HBA_ADAPT_SHUT_ENA
I am not sure about different hardware. I didn't think there was when I first looked into this.
|
With the Xenon headlights for the F22, there is no hardware difference, like some claim; the technology is very rudimentary in its operation, as it's just a low/high-beam shutter and the projector ball on a swivel motor, in both the US-spec and Euro headlights. So if your vehicle already has the High-Beam Assistance option, there is no reason if you code in the European operation of VLD & GFHB, which would operate properly on the US-spec vehicles, since they share the same setup.
Xenon folks just lucked out in the US but you also need High Beam Assistance option ( 5AC) for it to work properly.
With the LCI LEDs, however, it operates different than Xenons hi/low shutter and instead utilizes an array of LEDs and reflection to create the light outputs.
So I'm not 100% sure if VLD or GFHB in the US-spec vehicles have proper arrangement of lights to properly form a glare free high beam.
BMW is know to skimp to LEDs highlight array when it's not needed, as with some US-spec vehicles, in an attempt to reduce cost and heat. So I can't confirm if they differ until some cracks open a F22 LED headlight, from both region and compare and contrast.
Also, the coding is different for the LCI LED headlights than for the Xenons, which is listed above.
|
Sorry I am a little unclear; so the coding quoted in your post does not apply to LCI LEDs, but only to pre-LCI xenons? Is that it?
|
That's correct; the coding listed only works for Adaptive Xenons with the Auto-High beam option.
The LCI LED coding is way more intricate.
|
Can you guide me to it? I have a 2018 M240i with Adaotives so I assume it has the post-LCI LEDs?
|
I don't have the tested F22 LED coding but it should be the same as the M4.
Keep in mind, no one has yet confirm that the LED array in the US-spec headlights are the same as the Euro-spec. So there is a possible it would not work as it suppose to if it doesn't have the correct hardware.
https://www.bimmerpost.com/forums/sh...php?p=24640779
https://f80.bimmerpost.com/forums/sh....php?t=1151903
It's not something you can code with BimmerCode.